Parts Included; Initial Setup Of App - Volvo Penta NMEA2000 Easy Connect Instrucciones De Montaje

Purpose
Install bluetooth interface, Easy Connect, on to boat/
engine's electronic network.
Bluetooth code
Note: you will need the six-digit bluetooth code printed
on the interface label for connection to your device
(phone, tablet, etc.). See C in Fig. 6. Record the code
number before mounting the interface.
Record code here: _________________________

Parts Included;

Kit 23114628, interface
qty P/N
1 23096384
2 948210
1 47708900
Kit 23194818, for EVC and MDI
qty P/N
1 23096384
2 948210
1 23197513
1 47708900
Kit 23194833, for gas, non-EVC
qty P/N
1 23096384
2 948210
1 23132012
1 47708900
Installation
WARNING! to prevent accidental starting,
disconnect engine power at the battery switch,
tag battery switch and all ignition switches to
alert others that work is being done on the
engine.
The interface must be mounted securely, away from
moving parts, excess heat, and wet areas. Use the
cable ties to secure the interface.
All cable installations must meet ABYC, USCG, EU and
other applicable regulations and standards.
Mount the interface where the LED lights can be seen
if needed, for system diagnostics.
EVC-E and EVC-D (all versions)
Connect interface to the multilink hub according to
figure 1;
option A - directly to hub, or
option B - use Y-cable to install in-line
Gas engines without EVC
Connect interface to the connector labeled Vodia on the
engine harness, according to figure 2. The connector is
47708900 01-2018 © AB Volvo Penta
Description
interface
Cable tie
Instructions
Description
interface
Cable tie
Harness, Y
Instructions
Description
interface
Cable tie
Harness, adapter
Instructions
usually located near the fuse box.You must use the
adapter harness to complete the installation.
For twin installations, mount an interface on each
engine.
The Vodia connector is still powered at key off; the
LEDs are still active and will draw a very small amount
of current. During storage this could drain the batteries.
Disconnect engine electrical power to prevent.
EVC-C (all versions)
Connect the interface to the HCU according to figure 3.
EVC-B
Connect the interface to the HCU according to figure 4.
EVC-A
Not supported.
MDI
Connect the interface to the MDI according to figure 5.
NMEA2000
The interface will also broadcast data from the boat's
NMEA2000 network. Connect the interface's
NMEA2000 connector to the NMEA2000 backbone to
access this data.
System Status LEDs
See figure 6.
G - Green LED - diagnostics;
Flashes On-Off-On-Off-On, the device has power
supply and communication on both NMEA and EVC/
Engine.
On constantly, the unit has power supply but no
communication, either on NMEA or EVC/Engine.
Flashing twice and then off (500ms), repeatedly, then
the unit has power supply and communication on EVC/
Engine but not on NMEA.
Flashing three times and then off (500ms), repeatedly,
then the unit has power supply and communication on
NMEA but not on EVC/Engine.
B - Blue LED - bluetooth status;
Flashes On-Off-On-Off-On, unit is paired and working.
Not lit, Bluetooth device in interface is not working.
On constantly, Bluetooth interface is working but not
paired.
Flashing twice and then off (500ms), repeatedly, error
in Bluetooth communication.

Initial setup of app

Visit the following site for instructions for connecting
and operating the Easy Connect device;
http://manual.volvopenta.com/coupon/
Enter publication number 47710279.
5