Technical Specifications - GiBiDi SC230 Manual De Instrucciones

SC230

TECHNICAL SPECIFICATIONS

Control unit
Type
Power supply
No. of motors
Motor power supply
Flashlight
Warning light
Accessory power supply
Safety device power supply
Radio-receiver
Operating temperature
Working time
Pause time
FEATURES / FUNCTIONS
•Red warning LEDs of N.C. contacts (photocell, safety device, closing limit switch, opening limit switch, stop).
•Green warning LEDs of N.O. contacts (start and ped).
•Buttons START and PED on board.
•Safety test runs before the opening and closing movements.
•Deceleration during opening and closing controlled by 2 additional magnets to be assembled in the desired
position at a minimum relative distance of at least 500 mm. Deceleration is adjustable with a trimmer (SLOW).
•Stop and motion inversion for 2 seconds after intervention of the safety devices. At the next Star t pulse the motion
restarts in the obstacle freeing direction.
•Possibility of reading the motor rpm for the anti-crushing function by means of a sensor, both during normal
operation and in slow motion. The intervention of the sensor determines stopping and inversion of the motion for 2
seconds. At the next Start pulse the motion restar ts in the obstacle freeing direction.
•Pedestrian operation with fixed opening of 10 seconds. The automatic function and automatic closing are always
enabled.
•SAFETY DEVICE POWER SUPPLY. Connection to this power supply allows TESTING the devices before motion.
The safety devices must be connected to this terminal and will be powered only during the operating cycle.
Electronic control unit for automation of a sliding gate with 230
230VAC, single-phase, 50/60 Hz
24 VAC 8W max including safety device power supply
24 VAC 8W max including accessory power supply
Adjustable between 2 and 215 s
SC230
VAC motor
1
230 VAC
230 VAC 40W max
24 VAC 3W max
Plug-in
-20°C +60°C
240 s fixed
9
UK