Default Settings - RIB R-CRX 2.0 Manual Del Usuario

7. Selectable functions through dip-switch
It is important to change the configuration of the dip-switch only when the unit is turned off!!!
Turn off the power supply during the change of configuration.

Default settings

The control board is supplied with the dip-switches set as indicated in the Pict. 1.
In the table are sum up the functions that can be selected through these dip-switches.
Fig.1
7.1 Functioning on opening/closing
This function enables to select the method of opening/closing of the automation.
ON
OFF
ON
OFF
ON
OFF
ON
OFF
The operating mode with "pulse function" activated can be selected by the dip 4.
7.2 Working
time
The setting of this dip enables to choose between a working time manually set through a trimmer or an infinite working time.
ON
An infinite working time is set, the output remains activated till the reception of a stop or an opposite motion impulse.
The pause time for automatic closing, even if it is set, will not be implemented.
OFF
ON
The working time is manually set through the "Run Timer" trimmer adjustment (see paragraph 6).
OFF
dip
1 Function on opening
2 Function on closing
3 Working time
4 Pulse functioning
The automation operates under dead man mode on opening.
The automation operates under pulse mode on opening.
The automation operates under dead man under on closing.
The pause time for automatic closing, even if it is set, will not be implemented.
The automation operates under pulse mode on closing.
Function Dip OFF
Dead man
Dead man
Programmable
Open - Close
19
Dip ON
Impulse on opening
Impulse on closing
Infinite
Step by step (function GO)
G
B