Pressure Relief Valves - Holmatro SCV 10 U Manual

6.4 The system is damaged
/i
Possible cause
Damage and/or distortion.
7 Maintenance
7.1 General
Meticulous maintenance of the equipment preserves the operational safety and extends the life of the
equipment.
WARNING
When performing maintenance activities, always comply with the relevant safety regulations.
Wear the prescribed personal protection equipment.
7.1.1 Dangerous substances
WARNING
Any harmful products that are consumed during the activities, must be collected and
disposed of in an environmentally responsible way.
7.2 Inspection
Inspect the control unit for damage after each use.
7.3

Pressure relief valves

Regularly check the operation of the pressure relief valves.
• Connect the control unit to a compressed air source with a pressure of approx. 10 bar (via a
pressure regulator, for example).
• Do not connect a tool.
• Slowly increase the regulator pressure while keeping one push-button in its "+" position.
• The pressure relief valve must open at a pressure between 8 and 9 bar.
• Test any other pressure relief valves by the same procedure.
• Contact your Holmatro dealer if the pressure relief valve opens too early or too late.
8 Decommissioning/Recycling
At the end of its service life the equipment can be scrapped and recycled.
• Make sure that the equipment is put out of order to avoid any use.
• Check that the equipment does not contain any pressurized components.
• Recycle the various materials used in the equipment such as steel, aluminium, NBR (Nitrile
Butadiene Rubber) and plastic.
• Collect all dangerous substances separately and dispose of them in an environmentally responsible
way.
• Consult the Holmatro dealer about recycling.
SCV/DCV 10 U
Solution
Immediately stop using the tool and present it to
your Holmatro Dealer, or a Holmatro Certified
Technician, for inspection.
916.279.030_002
EN
17