Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Assembly (continued)
A Phillps head screw driver is required.
1
2
6
5
WARNING: Do not plug in power cord to power outlet, make sure plug is
disconnected before assembling the wet/dry vac.
GENERAL ASSEMBLY INSTRUCTIONS
1. Verify that the power cord is
disconnected from the outlet. (Fig. 1)
2. Undo the latches and lift the power
head off of the collection tank.
(Fig. 2)
3. Remove the hardware package from
inside the collection tank. (Fig. 3)
4. Place the collection tank upside
down and insert the casters into
the sockets on the bottom of the
collection tank. Ensure each caster
is aligned straight into the collection
tank and apply pressure until the
casters snap into place. Use a hand
to support the base of the collection
tank when pressing in the casters.
(Fig. 4)
5. Insert the handle into the slots
located on the top of the power
head and secure it with the screws
provided. Do not overtighten the
screws. (Fig. 5)
3
4
7
8
6. Place the power head back on the
collection tank, and secure into
place using the 2 side latches.
(Fig. 6)
7. Insert the locking end of the hose
into the port on the collection tank
and turn clockwise to lock in to
place. (Fig. 7)
8. Choose the desired accessory and
insert onto the end of the hose.
(Fig. 8)
9. After vac use, store hose,
accessories and cord as illustrated
on page 12.
Note that a static discharge chain is
attached to the bottom of the tank. It
is normal for this chain to drag on the
ground. Operating the vacuum in dry
conditions can build up static, and the
chain helps dissipate any build-up by
allowing it a path of least resistance to
the ground.
6
Capítulos
Tabla de contenido
