Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Important: Before you use it for the first time, disassemble the unit (see
HOW TO DISASSEMBLE section); wash all parts as instructed in the CARE
AND CLEANING section.
HOW TO ASS E M B L E A ND USE
1.
Place the pulp separator on the base with the
pieces aligned as shown (F).
2.
Insert the cutter/strainer in the center of the pulp
separator. Press down until it snaps into place (G).
3.
Place the clear cover on top of the pulp separator
with pusher in place (H).
4.
Lock the safety locking latches on both sides. Fit
the tab at the top of each latch into the groove
on each side of the cover and press the bottom of
each latch until you hear it click into place (I).
Important: The unit will not operate until both of the
safety locking latches are locked.
5.
Grip the pulp container and slide it in top-first until
it snaps into place (J).
Important: Do not operate juice extractor without
pulp container in place.
6.
Place a glass under the juice spout (K).
7.
Cut food into pieces to fit the food chute.
8.
Plug the power cord into an outlet. Press the on/off
(I/0) switch to the on (I) position.
9.
Place food in the food chute and press lightly
with pusher.
10. When the pulp container is almost full, turn the
unit off (0) and unplug from outlet. Empty the pulp
container and clean the cutter/strainer before you
start juicing again.
Caution: The cutter/strainer teeth are very sharp.
Handle carefully.
11. When juicing is completed, turn the unit off (0) and
unplug from outlet.
6
F
G
H
I
J
K
Tabla de contenido
