How To Use; Vh102 Controls; Vh2 Controls; Resetting Your Vornado Heater - Vornado VH102 Guia Del Propietario

How To Use

VH102 Controls

1 Power On/Off
Illuminated when the unit is On.
Thermostat
2
4 3
Allows you to select your desired
comfort level.
For fan only use - select the Fan
2
setting and press Cont. on the
Fan switch.
1
Fan
3
In the Auto position, the fan will
cycle on and off with the heating
4 Heat
element. In the Cont. position,
(I) Low Heat 750 watts
the fan will run continuously.
(II) Medium Heat 1125 watts
(III) High Heat 1500 watts

VH2 Controls

Power On/Off
1
Illuminated when the unit is On.
Thermostat
2
4 3
Allows you to select your desired
comfort level.
3 Fan
2
In the Auto position, the fan will
cycle on and off with the heating
1
element. In the Cont. position,
the fan will run continuously.
4
Heat
Low Heat 750 watts
High Heat 1500 watts
6 English
Getting Started
Using your Vornado Heater is easy. Just follow these simple
steps.
1. Position your heater so the vortex beam of warm air is
directed across the room, unobstructed. Position it in a
location that is representative of the room temperature.
Avoid areas of temperature extremes such as cold drafts and
heat registers (refer to IMPORTANT INSTRUCTIONS for safe
placement).
2. Plug power cord into standard wall outlet.
3. Set Power switch to On.
4. Select High or Low heat.
5. Set Thermostat to the highest setting. When the room
reaches the desired comfort level, turn the Thermostat knob
slowly counterclockwise until the heat cycles off (easier to
detect when Fan is set to Auto).
How To Use

Resetting Your Vornado Heater

Your Vornado Heater has a multi-level safety shut-off system
designed to prevent overheating. Overheating may occur
when the inlets or outlet are blocked, a foreign object
prevents the blade from turning, or the appliance tips over. If
this happens, the safety shut-off system will cut power to the
heat element and you will need to manually reset the heater.
1. Set the Power switch to Off and unplug the unit.
2. Remove any obstructions.
3. Wait 5 –10 minutes, allowing the unit to cool down.
4. Plug in the unit and place in desired position.
5. Set the Power switch to On. Your Vornado Heater should
now function normally.
Note: If the safety shut-off system repeatedly shuts off
your heater or if it will not reset after following the above
procedure, DO NOT ATTEMPT TO DISASSEMBLE THE UNIT.
Call Vornado Consumer Services Department toll-free at
1-800-234-0604.

Advanced Safety Features

Tight Grill Spirals
Resists curious fingers.
Cool Touch Case
Safe to touch, even on high heat setting.
Automatic Safety Shut Off System
If airflow becomes blocked and overheating occurs,
power to the heating element is shut off.
Tip-Over Protection
Heater will automatically shut off if tipped towards
the front or back.
Ideal 120°F Exit Air Temperature
Warm enough to heat an entire room.
English
7