DECLARATIONS OF CONFORMITY
USA/Canada/New Zealand/Australia
In this region the Barryvox
W-Link operates in the 915MHz band.
®
Type / Model: Barryvox
S 7600.0033
®
IC: 8038A-BARRYVOXS
FCC ID: ARN-BARRYVOX-S
C a n a d a : I C S t a t e m e n t
This device complies with Industry Canada licence-exempt RSS
standard(s).
Operation is subject to the following two conditions:
1. This device may not cause interference and
2. This device must accept any interference, including interference
that causes undesired operation of the device
Le presént appareil est conforme CNR d'Industrie Canada
applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes:
1. l'appareil ne doit pas produire de brouillage, et
2. l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est suscep-
tible d'en compromettre le fonctionnement
BARRYVOX
S
GUÌA DE REFERENCIA
®
U S A : F C C S t a t e m e n t
This equipment has been tested and found to comply with the limits
for Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residual installation. This equipment ge-
nerates, uses and can radiate frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guaran-
E5720
tee that interference will not occur in a particular installation. If this
equipment does harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the
following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
• To assure continued compliance, any changes or modifications
not expressly approved by the party responsible for compliance
could void the user's authority to operate this equipment.
This device complies with the Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including in-
terference that may cause undesired operation.
DECLARACIÓN DE CONFORMIDAD
63