Secure Router 4134 Internal Module Installation And Removal; Removing The Secure Router 4134 Service Access Panel - Avaya 2330 Manual Del Usario

Ocultar thumbs Ver también para 2330:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

English
3. Release the latches that secure the PVIM in the slot. There is a release latch at both
4. Firmly grasp the edges of the PVIM and pull straight up to remove the PVIM from
5. If you are not installing a PVIM module at this time, replace the chassis top cover.

Secure Router 4134 internal module installation and removal

This section provides information for installing and removing Secure Router 4134 internal
modules.

Removing the Secure Router 4134 service access panel

Use the instructions in this procedure to remove the Secure Router 4134 service access
panel.
Voltage:
Do not open the Secure Router 4134 service access panel while the unit is powered.
Prerequisites
• Ensure you have a module ready to install before opening the service access panel.
• Ensure you have a Phillips #2 screwdriver.
• Ensure the Secure Router 4134 is powered off. You cannot hot swap internal
components.
1. Remove the two screws at the rear of the Secure Router 4134 that hold the service
28
Regulatory Information
ends of the PVIM slot.
the slot.
access panel secure. Remove these two screws only.
See the following figure for reference.
August 2013
Tabla de contenido
loading

Este manual también es adecuado para:

4134

Tabla de contenido