Idiomas disponibles
Idiomas disponibles
OBJ_BUCH-0000000276-001.book Page 21 Monday, July 31, 2017 1:42 PM
Repair and customer service.
Before mounting or replacing cutting tool or accessories, pull the power plug.
WARNING
This preventive safety measure rules out the danger of injuries through acciden-
tal starting of the power tool.
Exchangeable parts
If required, you can change the following
parts yourself:
Application tools, handles, chip guard, safety
strap
Cooling-lubricant system.
Flush the cooling-lubricant system with
water, clean and drain it completely when not
using the machine for periods longer than
two weeks.
For continuous operation, the cooling-lubri-
cant system must be flushed with water and
cleaned approx. every 4 weeks.
Service.
Have maintenance carried out
WARNING
only through qualified person-
nel. Incorrectly mounted cables and compo-
nents can cause serious injuries. Have the
required service carried out only through an
authorized Slugger repair facility.
When replacing the power
CAUTION
tool's protective cable bushing
or cord between the drill stand and drill
motor is required, this must be carried out by
Slugger or by an authorized Slugger Service
Agent, in order to avoid hazardous situations.
The current spare parts list for this power
tool can be found in the Internet at
www.fein.com.
Warranty and liability.
The warranty for the product is valid in accordance with the legal regulations in the country
where it is marketed.
Environmental protection, disposal.
Packaging worn out power tools and accessories should be sorted for environmentally friendly
recycling. Further information can be obtained from your dealer.
Cleaning.
Prior to any cleaning or main-
WARNING
tenance, disconnect the power
tool from the power supply in order to avoid
accidents.
When using in environments
WARNING
with conductive dust in the air,
such as when working metals, this dust can
settle in the interior of the power tool. This
can impair the total insulation of the power
tool. Therefore, regularly blow out the interior
of the power tool from outside via the venti-
lation openings with dry, oil-free compressed
air; always wear eye protection when doing
this. For additional protection, connect a
residual current device (RCD) on the line side.
NOTE: Such a device is also known as a
(PRCD = portable residual current device) or
(GFCI = ground fault circuit interrupter) or
(ALCI = appliance leakage current inter-
rupter) or (ELCB = earth leakage braker).
Do not attempt to clean
CAUTION
clogged or dirty ventilation
openings of the power tool with pointed
metal objects; use nonmetal tools or objects
if necessary.
Do not use cleaning agents
CAUTION
and solvents that can cause
damage to plastic parts. These include: Gas-
oline, carbon-tetrachloride, chloric solvents,
ammonia and domestic cleaning agents that
contain ammonia.
en
21
