Operating Instructions; Important - Health O Meter 553KL Manual De Usuario

OPERATING INSTRUCTIONS

IMPORTANT: To prevent falls or injury, place the scale securely far from the edge of the
counter, table or other flat surface used to hold the scale. Do not let the scale touch the
wall or any other object near or around the scale while it is in use.
Weighing a Patient
1. Make sure there is nothing on the tray.
2. Press the ON/OFF button to turn on the scale. "88:8:8.8" followed by "0.0" will appear on the
display.
3. Place the baby on the scale so that its weight is evenly distributed on the tray. The scale will
begin to display weight information and will lock on the patient's weight when the stable
weight of the patient is determined. Depending on the movement of the patient on the scale,
it may take several seconds for the scale to lock onto the weight.
4. When a stable weight is calculated, a small ring along with the word "HOLD" will appear on
the display and the weight of the baby will lock.
4. Note: If the display shows "OVER" you have exceeded the capacity of the scale.
(553KL:44 lb / 20 kg; 553KG: 20 kg)
Caution: To prevent patient injury, the patient must be attended throughout the entire
weighing event.
5. Remove the baby from the scale. The scale will continue to display the baby's weight.
6. To return the scale to 0.0, press the RELEASE button and the scale will be ready to weigh
again.
Note: If "Lo" appears on the display, it indicates that the battery power is low. It does NOT
indicate a problem with the weight measurement.
Note: If Auto Off is enabled the scale will not power off if a weight is held on the display.
Press the RELEASE button to release the weight and allow the scale to power off
automatically.
Zero/Clear (TARE) Function
The tare function allows you to place other items on the scale while weighing the baby, without
affecting the baby's weight reading.
1. Place the item you want to tare on the weighing tray.
2. Press and release the ZERO/CLEAR button. The word "TARE" will appear on the display
and the display will return to 0.0.
3. Place the baby on the scale with the tared item and weigh normally. The scale will only
display the baby's weight.
Note: If there is no weight on the scale and it does not read 0.0, press the ZERO/CLEAR button
once to return the display to zero.
Changing the Weight Measuring Unit (553KL Only)
1. Press the ON button to power the scale on.
2. Wait for "0.0" LB or "0.0" KG to appear on the display.
3. Press the kg/LB button to toggle to the desired weight measuring unit.
Locking the Weight Measuring Unit in KG (553KL Only)
Note:
The weight measuring unit can be locked to only measure in KG.
1. Press the ON button to power the scale on.
2. Wait for "0.0" LB or "0.0" KG to appear on the display.
3. Press and hold the kg/LB button for approximately 20 seconds until "KG" flashes in the
lower right corner of the display. This locks the scale in KG mode and will not display weight
in pounds.
4. To release the KG lock, press the kg/LB button for approximately 20 seconds until "LB",
"OZ" and "KG" flash on the display. The user can now toggle the weight measuring unit
between LB and KG.
P/N UM553KL_553KG Rev20190412_web
7