First Use - Fahl VOICETEC 77350 Manual Del Usuario

3 operation of the voice amplifier
This chapter informs you about putting the Voicetec
first time.
3.1 general prerequisites
The Voicetec voice amplifier is ready for operation after removing from the packaging and ob-
®
serving the following provisions.
• Carry out a visual inspection for external damage. The device must be free of damage.
• If there is any damage, do not put the Voicetec
3.2

First use

Check whether all parts are included in the scope of delivery in accordance with the device over-
view (see chapter 2.2 / 2.3 of the Operating Instructions).
Please check that the transmitter unit
radio channel. Set the channel switch (
purpose. transmission is only possible with the same radio channel. if the connection on
one channel is faulty, change both devices to another value. if the transmitter and receiver
units are not set to the same radio channel, the control lamp
flashes green.
3.3 Preparing the transmitter unit for operation
• Inserting and changing batteries
You can optionally use two batteries (1.5 V type AA) or two rechargeable batteries (1.2 V Ni-MH
type AA) (included in the scope of delivery) for operation. The rechargeable batteries can be
charged in the battery compartment
any commercially available charger. Press on the release button of the battery compartment
and fold open the cover. Insert the batteries
You can identify the polarity from the sticker inside the battery compartment. Close the battery
compartment. The cover locks in place audibly.
• Connect the microphone
Connect one of the three microphones
phone with the microphone input socket
• Switch on the transmitter unit
Switch on the transmitter unit with the On /Off switch
must now light green.
• Setting the microphone
Depending on which microphone you use, configure it such that it is as close as possible to the
tracheostoma. You can set the volume of the transmitter unit with the volume control
to the left reduces the volume, to the right increases the volume.
3.4 Preparing the receiver unit for operation
• Inserting and changing rechargeable batteries
Only rechargeable batteries (1.2 V Ni-MH type AA) may be used for operation.
do not use normal 1.5 V type aa batteries. the receiver unit may be destroyed on connec-
ting the power supply connector
voice amplifier into operation safely for the
®
voice amplifier into operation.
®
and the receiver unit
1
or ) to the same value (a or B or c) for this
11 21
of the receiver unit (see description in chap. 3.4) or with
20
. Ensure that the polarity is correct when inserting.
5
, , supplied. Connect the socket plug of the micro-
2 3 4
of the transmitter unit.
6
. The control lamp
8
.
13
19
are working on the same
13
on the transmitter unit
9
of the transmitter unit
9
. Turning
7
EN
10