Downloading Stored Data; Operation Of Efas - Controlling Bodies; Displaying Data - intellic EFAS Manual De Instrucciones

Having pressed OK, you may enter the settings for the driver at Ignition OFF, and thereafter the
settings for the co-driver.
6.3

Downloading Stored Data

The data that is stored in the digital tachograph can be downloaded by using a suitable external device.
You can only download the data for drivers from your company. However it is important that your com-
pany was or is registered on the digital tachograph (see section 6.1).
Proceed as follows:
1. Turn on the ignition.
2. Insert your company card into one of the card slots. The second slot must either be empty or con-
tain a driver card.
3. Open the cover of the interface on the front side. To do so, stick your fingernail into the groove
above the cover, pull out the flap and fold it down.
4. Connect the external device to the interface.
5. Start the download at the external device.
While data is being downloaded from the digital tachograph, a flashing twin arrow is displayed. Do not
disconnect the data connection to the digital tachograph EFAS before the download is completed.
7 Operation of EFAS – Controlling Bodies
Inserting your control card enables you to display, print, or download all data that is stored in EFAS and
on a driver card, independently of any company locks. At this time, the other card slot should be occu-
pied either by no other card or by one driver card only.
7.1

Displaying Data

Select OK Print preview and confirm with OK. The menu for the
1.
stored data is displayed.
Select the required data and confirm with OK.
2.
3. Use control keys
OK. The stored data is displayed.
4. Press to display the next line or
5. Press to close the print preview.
The display shows Start Printout?.
Use control keys to select the desired answer and acknowledge with OK.
6.
7.2 Downloading Stored Data
1. Turn on the ignition.
2. Make sure your control card is inserted into one of the card slots. The second card slot must be
empty or contain a driver card.
3. Open the cap of the service-interface at the front of the device and connect the external device for
data download to the interface.
4. Start the download at the external device.
While data is being downloaded from the digital tachograph, a flashing twin arrow is displayed. If you
insert a tachograph card into a card reader slot during a download, the card will only be read by EFAS,
after the download has completed. Do not disconnect the data connection to the digital tachograph
before the download is complete.
or to select the required date and confirm with
to display the previous line.
14