Auto Mode; Sleep Function - Kenmore 407.83086 Manual De Uso Y Cuidado

AUTO MODE
• Place the unit in the room the desired room.
• The exhaust hose must be connected and properly installed to coo[ or dehumidify the
room properly. See the INSTALLATION instructions on page 9-10 of this USE AND CARE
GUIDE.
• Use the MODE button on the remote to set the unit function to Auto. The set temperature
does not appear on the display and cannot be adjusted in Auto Mode.
• Once in auto mode the unit will automatically select the mode based on current room
temperatu re.
AUTO MODE SETTINGS
_" .... ' "_" . _...... _._., _ _ . _"_._.' ._ .,: ....... . _._
Below 68°F Fan Mode
68°F - 78°F Dry Mode
79°F or Greater Cool Mode
NOTE: If room temperature is 68°F - 73°F and the mode was previously set to Fan before
changing to Auto, it will default to Fan mode. When room temperature is 74°!: - 78°F, it will
default to Dry mode.
SLEEP FUNCTION
• While in cooling mode, set desired temperature by pressing the up and down arrow but-
tons on the unit control panel or - and -I- buttons on the remote. Cooling temperature can
be set from 61°F to B6°F.
• Adjust the fan speed from Low, Med, High and Auto by pressing the FAN button on the
remote control.
• Press SLEEPbutton on the remote control to activate this function. Sleep will only operate
in cooling mode.
• When Sleep is activated, the set temperature will automatically increase 2°F after I hour.
After another hour, the set temperature will increase another 2°F for a total increase of
4°F.
• To cancel Sleep, press the SLEEPbutton on the remote or MODE button on the unit con-
trol panel or remote.
NOTE: The displayed set temperature on unit control panel and remote will remain at its
initial set position while Sleep function is enabled
15