Using The App On Several Devices; Resetting The Baby Monitor - Philips AVENT SCD870 Manual De Instrucciones

3 Follow the rest of the on-screen instructions to complete setup.
The setup procedure is completed and the baby monitor is
connected to the WiFi network and ready for use, when the WiFi
status light on the front of the baby monitor turns solid green.
Note: When you return home, you have to follow the procedure above to
reconnect the baby monitor to your home WiFi network.

Using the app on several devices

You can use the uGrow Smart Baby Monitor app on more than one device
(e.g. on your iPhone and your iPad).
Note: When you log in with the same account on a device while the app is
active on another device, the device on which the app was active first will
automatically log you out. You cannot use the app under the same account on
two different devices simultaneously.

Resetting the baby monitor

The baby monitor has a reset button on the back. When you press this
button the baby monitor is reset to its factory default settings. This means
that you disassociate all accounts from the baby monitor.
Note: Always reset the baby monitor by pressing the reset button before you
transfer the baby monitor to someone else. This is necessary to protect your
privacy. Also reset the baby monitor when you buy or receive it second-hand.
How to reset to factory default settings
Note: Make sure the baby monitor is switched on before you reset it.
1 While the baby monitor is on, press the reset button on the back
of the baby monitor with a paperclip or another pointed object. It
is recommended to do this when the baby monitor is connected to
your WiFi network.
2 Keep the reset button pressed until the baby monitor beeps, then
you can release the button. When you release the button, the baby
monitor plays a short tune to confirm the reset.
What to do after a reset to factory default settings
After the baby monitor has been reset, the WiFi status light flashes orange
when you switch on the baby monitor to indicate that it is rebooting after
a reset. When the WiFi status light stops flashing, you can connect the baby
monitor to your WiFi network again. Follow the instructions in chapter
'First-time setup' in this user manual. If you invited other people to access
the baby monitor, you need to invite them again.
ENGLISH
21