Care And Cleaning; Metal Grease Filter; Charcoal Filter; Grease Filters - GE Profile PV970 Serie Manual Del Propietario E Instrucciones De Instalación

Care and cleaning of the vent hood.
Be sure electrical power is off and all surfaces are cool before cleaning or servicing any part
of the vent hood.
Locking tab handle

Metal Grease Filter

The metal filter traps grease
released by foods from the
cooktop. The filter also helps
prevent flames (from food, grease)
from damaging the inside
of the hood.
For this reason, the filter
must ALWAYS be in place when
the hood is in use. The grease filter
is dishwasher-safe and should be
cleaned every 6 months, or as
needed.

Charcoal Filter

If the model is not vented to the
outside, the air will be recirculated
through a disposable charcoal filter
that helps remove smoke and odors.
The charcoal filter should be
replaced when it is noticeably dirty
or discolored (usually after 6 to 12
months, depending on hood usage).
NOTE: DO NOT rinse, or put charcoal
filter in an automatic dishwasher.
The charcoal filter cannot be
cleaned. It must be replaced.
Order Charcoal Filter WB02X11348.
To inquire about purchasing
replacement charcoal filters or to find
the location of a dealer nearest you,
please call our toll-free number:
National Parts Center
Locking tab handle
800.626.2002
To remove:
Pull downward on the filter lock
to release the filter.
To replace:
Fit the tabs at the end of the filter
into the slots in the left side of the
filter opening. Lift up the right side
of the filter and push gently until
the filter locks into place. Make
sure the filter lock is in the closed
position to secure the filter.
To clean, swish the filter in hot
soapy water and rinse in clean
water or wash it in the dishwasher.
Do not use abrasive cleansers.
NOTE: Some discoloration will occur
in the dishwasher.
(for recirculating installation only)
To remove:
1. Remove the metal filter—see Metal
grease filter section.
2. Remove the charcoal filter by
pushing in on both locking tab
handles to release.
To replace:
1. Insert the charcoal filter into the
opening. Push the locking tab
handles toward the center and
release to engage the locking tabs.
2. Replace the metal filter—see Metal
grease filter section.
ge.com
5