Shark NV370 Guia Del Usuario página 13

Suction
Release Collar
c
Release suction
for easier push &
pull on high pile
carpets and
area rugs.
b
TO USE:
1
Rotate the cord release to quickly release the power
cord.
2
Secure the power cord in the cord hook.
= Brush Roll ON
= Bare Floor
= OFF
3 Press the On/Off switch (a) to the "I" position to
vacuum bare floors (straight suction only) or to the
"II" position to engage the motorized floor brush (for
vacuuming carpets and rugs). (Fig. 11)
IMPORTANT: The motorized brush indicator light
(b) will illuminate green when motorized floor brush
is on, or red if there is a blockage or jam. (Fig. 11)
This feature is designed to protect your Lifetime
Belt that powers your motorized floor brush. See
Checking for Blockages on page 20.
a
Fig. 11
Fig. 12
4
Gently press the floor nozzle down with your foot
while you grasp the handle and tilt it back towards
you. (Fig. 12)
NOTE: The rotating brush on the motorized floor
brush will not spin unless the nozzle is flat against
the floor and the handle is tilted back.
5
Due to the huge suction power of this vacuum,
it may become necessary at times to adjust the
suction release (c) on the handle. (Fig. 10) If the
vacuum seems difficult to push or pull or if it is
lifting up area rugs, adjust the suction release
by rotating the collar 90° counterclockwise to
open the valve. Rotate the collar clockwise to
close the valve when you need high suction and
for vacuuming floors.
6
Empty dust cup after vacuuming and periodically
during use when it appears full. (See "Maintenance"
section for instructions.)
7
When you are finished vacuuming, turn the
vacuum off.
www.sharkclean.com 13