Tabla de contenido
FOR USA AND CANADA MARKET ONLY: SPECIAL WARNING
This device complies with part 15 of the FCC and Industry Canada Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications could void the user's authority to operate the equipment.
This product has been tested and complies with the specifications for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used according to the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which is found by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment or devices
Connect the equipment to an outlet other than the receiver's
Consult a dealer or an experienced radio/TV technician for assistance
This model meets the government's requirements for exposure to radio waves. Your wireless device is a radio
transmitter and receiver. It is designed and manufactured not to exceed limits for exposure to radio frequency
(RF) energy set by the Federal Communications Commission (FCC) of the U.S. Government and by the Canadian
regulatory authorities.
The exposure standard for wireless mobile devices employs a unit of measurement known as the Specific
Absorption Rate, or SAR. The SAR limit set by the FCC and by the Canadian regulatory authorities is 1.6 W/kg.1
Tests for SAR are conducted using standard operating positions accepted by the FCC and by Industry Canada
with the device transmitting at its highest certified power level in all tested frequency bands.
The highest SAR value for this model device when tested for use at the ear is 0,190 W/kg.
For Canada market only: This EUT is compliant with SAR for general population/uncontrolled exposure limits in IC
RSS-102 and had been tested in accordance with the measurement methods and procedures specified in IEEE
1528.
FccID: Y6MNCOM3
Bluetooth is a registered trademark property of Bluetooth SIG, Inc.
2
21550
Tabla de contenido
