Troubleshooting; Before Calling For Service; The Air Conditioner - Kenmore 580.75062 Manual Del Propietário

BEFORE CALLING FOR SERVICE
Check the following list to be sure a service call is really necessary. A quick reference to this manual may
help you avoid an unneeded service call.
THE AIR CONDITIONER WILL NOT OPERATE
Check if...
Wall plug disconnected.
House fuse blown or circuit breaker tripped.
Power is OFF.
Unit was turned off and then on too quickly,
TEMP Control set warmer than room temperature.
The current interrupter device is triped
Then...
Push plug firmIy into wall outlet.
Replace fuse with time delay type or reset circuit breaker.
Push the power button.
Set unit off and wait 3 minutes before restarting.
Set TEMP Control to a tower temperature.
Press the RESET button located on the power cord plug
If the RESET button wilI not stay engaged, discontinue use of the air
conditioner and contact a qualified service technician.
AIR FROM UNIT DOES NOT FEEL COLD ENOUGH.
Check if... Then...
FAN SPEED set at LOW. Push FAN SPEED button to set at HIGH.
TEMP Control set too warm. Set TEMP Control to a lower temperature.
Room temperature below 70°F (21°C). Cooling may not occur until room temperature rises above 70°F (21°C).
Temperature sensing tube touching evaporator coil, Straighten tube away from evaporator coil
located behind front griIle.
THE AIR CONDITIONER
COOLING,
BUT ROOM IS TOO
WARM-ICE
FORMING ON COOLING COIL BEHIND FRONT GRILLE.
Check if... Then...
Outdoor temperature below 70°F (21°C). To defrost the coil, set the MODE to FAN, Fan speed to High.
Air filter may be dirty. Clean air filter. Refer to Maintenance section of owner's manual
TEMP Control set too low. To defrostthe coil,set the MODE to Coot, Fan speed to high, and the
Temp control to a higher temperature.
THE AIR CONDITIONERCOOLING, BUTROOM IS TOO WARM
Check if... Then...
Dirty air filter- air restricted. Clean air filter. Refer to Maintenance section of owner's manual
TEMP Control set too warm. Set TEMP Control to a lower temperature.
Front of unit is blocked by drapes, blinds, furniture, etc. Clear blockage in front of unit.
Air distribution is restricted.
Doors, windows, registers, etc. open. Cold air escapes. Close doors, windows, registers, etc.
Unit recently turned on in hot room. Allow additional t ime to removestoredheatfrom wails,ceiling,floor,andfurniture.
THE AIR CONDITIONER TURNS ON AND OFF RAPIDLY.
Check if... Then...
I Outside temperature is extremely hot. I Set FAN SPEED on LOW to minimize the cooling load. I
NOISE WHEN UNIT IS COOLING.
Check if... Then...
Sound of fan hittingwater- from the moisture removal system. This is normal when humidity is high. Close doors, windows, and registers.
Window vibration - poor installation. Refer to nsta at on nstruct ons or check w th nsta er.
WATER DRIPPING INSIDE ROOM WHEN UNIT IS COOLING.
Check if... Then...
The air conditioner is improperly installed. Tittinstallationair conditionerinstructionsSlightiYor tOcheckthe outsidewith instaIIer.t° allow water drainage. Refer to
WATER DRIPPING OUTSIDE WHEN UNIT IS COOLING.
Check if... Then...
The unit is removing large quantities of moisture This is normal during excessively humid days.
from humid room.
-14-