HURAKAN HKN-BCF3 Manual Del Usuario página 56

EN
➢ when the temperature of the thermal probe reaches the set value,
- the device switches to the storage mode;
- icon flashes, and
- the information on the "End" of the cycle is displayed;
- the device provides the sound alarm;
- press any button to stop the sound alarm, press again to remove the "End" message.
During storage:
➢ the chamber temperature is displayed;
➢ If the cooling was completed successfully,
the cooling required additional time,
icon flashes;
➢ press
- to display nEg message;
- to exit the mode (or leave for 15 sec for the device exiting the mode independently).
To stop the cycle:
➢ press and hold
10.3. HKN-BCF3, HKN-BCF5, HKN-BCF10, HKN-BCF14 control panel
display
Dixell XB590L master controller is used in HKN-BCF3, HKN-BCF5, HKN-BCF10, HKN-
BCF14 models.
The controller has the following features:
➢ possibility to stop any cooling/freezing cycle;
➢ possibility to use in each cycle up to 3 thermal probes or the thermal probe with 3
temperature sensors;
➢ defrosting during cycles is prevented, the fans are always running. The defrosting
cycle can be started before any cooling/freezing cycle;
➢ each cycle can be separated into 3 phases in compliance with the set parameters;
➢ the sound alarm warns of too low or too high temperature of the condenser;
➢ keeping the log of the last 15 accidents (high temperature, power failure and excess
of maximum cycle time);
➢ each device has the display connection;
56
indicator lights up;
several times:
button for 2 sec.
and
and indicators light up, and
indicators light up; if