Igniting The Pilot Burner; Igniting The Burner; Maintenance And Cleaning - Hobart G1009 Instrucciones Para La Instalación, El Uso Y El Mantenimiento

5.2

IGNITING THE PILOT BURNER

- To ignite the pilot burner (10 fig. 9), press the knob (3 fig. 2), turning it to the left onto the symbol (
position, press the knob in fully while pressing the piezoelectric ignition.
- The pilot flame, which can be seen through the hole in the front will light up; keep the knob pressed for approximately 15
seconds and then let go of it. If the pilot flame goes out, repeat the whole ignition process.
5.3

IGNITING THE BURNER

- To light the burner (10 fig. 9), turn the knob onto (
- To switch off the burner (10 fig. 9), turn the knob back onto (
( ).
6.
- Clean the stainless steel parts every day with warm soapy water, then rinse thoroughly and dry carefully.
- You must never clean the stainless steel with scrub pads, wire brushes or common steel scrapers since they can deposit
ferrous particles that on oxidizing cause points of rust. It is possible to use stainless steel wool applied in the direction of the
satin finish.
PAN
- After emptying the pan of food, wash it thoroughly, using a nylon brush if necessary to get rid of any encrustations.
- If the unit is not to be used for a long time, give all the steel surfaces a good wipe over with a cloth lightly soaked in Vaseline
oil in order to apply a protective film. Periodically ventilate the rooms.
- Keep the pan lid raised when it is not used.
STAINLESS STEEL PARTS
- The stainless steel parts must also be cleaned with soapy water and then dried with a soft cloth.
- You can keep them shining brightly by periodically wiping them over with liquid (POLISH), an easily available product.
).
). To shut it down completely, turn the knobback onto
Mod.
G1009 G1509
G100I9 G150I9

MAINTENANCE AND CLEANING

- 19 -
); on reaching this
fig. 3
GB