Table of Contents
Warranty ...................................................3
Safety Information
PRECAUTIONS
□
Please read and understand this entire manual
before attempting to assemble, install, or operate
this light fixture.
□
This light fixture requires a 120-Volt AC power
source.
□
Some codes require installation by a qualified
electrician.
□
This light fixture must be properly grounded.
□
This light fixture should be installed outdoors to a
wall or eave.
□
The light fixture should be mounted approximately
8 ft. (2.4 m) above the ground. If the light fixture
is mounted higher than recommended, aiming the
sensor down will reduce the coverage area.
□
The light fixture/camera requires constant power
to operate. Whenever the power is turned on to
the light fixture (either for the first time or after
a power outage), the light requires a 60-second
boot-up period before the camera will be fully
operational.
Installation ................................................6
Operation...................................................8
WARNING: Turn the power off at the circuit breaker or
fuse. Place tape over the circuit breaker switch and verify
power is off at the light fixture.
WARNING: Risk of fire. Keep the lamp heads at least
2 in. (51 mm) from combustible materials.
CAUTION: Burn hazard. Allow the light fixture to cool
before touching.
NOTICE: Do not connect this light fixture to a dimmer switch or
timer.
□
Many states regulate the use of security cameras
and other recording devices. It is the purchaser's
sole responsibility to ensure compliance with all
applicable laws and to provide any legally required
notices. Check local laws regarding the use of any
recording devices and cameras prior to installation.
□
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
□
CAN ICES-3 (B)/NMB-3(B)
2