Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Other possible malfunctions and their elimination
If problems occur when using the device, the following points should be checked
and if necessary, the corresponding measures are to be taken:
Malfunction
The display remains blank when the
instrument is switched on although the
batteries are in place.
The device frequently fails to measure
the blood pressure values, or the values
measured are too low (too high).
Every measurement produces a different
value although the instrument functions
normally and the values displayed are
normal
Blood pressure measured differs from
those values measured by the doctor.
Trouble downloading measurements
to my PC
Remedy
1. Check batteries for correct polarity and if
necessary insert correctly.
2. If the display is unusual, re-insert batteries
or exchange them.
3. Be sure contrast is not turned too far down.
1. Check the positioning of the cuff.
2. Measure the blood pressure again in peace
and quiet. See section 5, Taking a
Measurement
1. Please read the following information and
the points listed under «Common sources of
error». Repeat the measurement.
Please note: Blood pressure fluctuates
continually so successive measurements
will show some variability.
1. Record the daily development of the values
and consult your doctor.
Please note: Individuals visiting their
doctor frequently experience anxiety
which can result in a higher reading at
the doctor's office than at home under
resting conditions.
Uninstall the software using uninstall feature
from the cd. Take the cd out. Restart PC.
Reinstall software. Turn on your wrist monitor
and put into PC Link mode. Make sure you have
measurements stored in User 1 or User 2 then
set on appropriate user (Not User 0). Attach
wrist monitor to computer via supplied USB
cable and click OK on computer screen.
17
Tabla de contenido
