Alice's Garden SHADO AWM3X2SC Manual Del Usaurio página 28

EN
STEP 3B: INSTALLING ON A WOODEN WALL
1. Drill the previously marked holes with a drill and 6mm bit. The holes must be at least 8cm deep.
2. Insert the wood screwsa
The side of the bracket with a notch must be pointing upwards.
3. Gently push in the screws and turn them manually at first, then tighten using the appropriate Allen key
or an adjustable spanner.
1
≥8cm
Drilled holes Ø6mm
STEP 4: INSTALLING THE AWNING
A
Once the brackets are installed correctly, you can start to install the awning.
2 people are needed for this step. Use a ladder to carry out the installation and make sure that it is stable.
1. Remove the bolts (screws + nuts) preinstalled on the front of each mounting bracket
2. Insert the torsion bar
3. Place and screw in the nut and bolt on each bracket.
1
If the torsion bar fits poorlu into the mounting brackets, loosen the nuts of a mounting bracket
slightly (on the wall) and repeat the installation. Make slight forward / backward movements un-
til the torsion bar is inserted into the brackets. Immediately tighten the loose nuts on the wall.
28
B
into the holes of the awning brackets
2
Wood screw Ø8mm
8
into the notch in the bracket.
2
2
,then into the pre-drilled beam.
3
4
2
3
2
2
.
30/09/2019