UFESA HF3000 Manual De Instrucciones página 10

Maintenance and operation
Preparing the appliance for operation
Place the appliance on a dry, flat surface
away from potential heat sources
(heating plates/panels, cookers, ovens,
etc.).
1
Remove the steam jet from the water tank.
2
Remove the water tank from the base of the
humidifier, lifting it up. Turn the water tank upside down.
3
Loosen the nut on the valve by turning it counter
clockwise.
The direction of unscrewing and screwing
is marked on the underside of the cap of
the valve.
4
Fill the water tank with clean water. The maximum
water tank capacity is about 1.7 liters.
Use cooled boiled water or distilled water.
The water temperature should not
exceed 40°C.
5
Replace the cap from the valve on the water tank
and turn it in a clockwise direction until the water tank
will be sealed.
The direction of unscrewing and screwing
is marked on the underside of the cap of
the valve.
6
Turn the container upside down and mount the
water tank by putting it on the base of the humidifier.
Mount the steam jet on the water tank. Water begins to
overflow to the base of the humidifier.
Starting the appliance
1
Connect the power cord into an electrical outlet.
2
To turn the appliance on, turn the control knob in
a clockwise direction until it clicks. You will see the blue
light on the indicator light, and humidifier begins to
emit steam.
Do not operate the appliance if the water
tank is empty.
3
Use the control knob to set the amount of
generated steam (LOW – for low amount; HIGH – for
high amount).
B
4
To switch the appliance off, turn the control knob to
the position
Automatic steam shut-off
The humidifier has an automatic steam off function,
which will be activated in the following cases:
a) If during operation of appliance the water level
drops below the required level, a safety switch
automatically stops the appliance operation, preventing
it from overheating.
ndicator light will flash red-blue, and
after some time you will see the red
light. After filling the tank and placing
the appliance on the base, the appliance will
start steaming again. You will see blue light on
the indicator light.
b) During operation, removing the water tank or
incorrect installation of the tank on the base of
humidifier will launch a safety switch that automatically
stops the machine, preventing it from overheating.
You will see red light on the indicator
light. After proper installation of the tank
on the base, the appliance will start
steaming again. You will see the blue light on
the indicator light.
Draining the base of humidifier
1
Turn the appliance off by turning the control knob
to position
outlet.
2
Empty the base of the humidifier removing the
accumulated water (as shown in the photo).
D
Pouring water out in the wrong way may
result in water entering the outlet of the
fan and consequently cause serious
damage to the humidifier.
If water gets into the fan outlet, contact
your service center.
. The indicator light goes out.
and disconnect the plug from the wall
C