Controls And Connections; Front View; Rear View - Tripp-Lite B007-008 Manual De Operación

200603163 93-2538 B007-008 manual.qxd

Controls and Connections

Front View:

1
Status LEDs:
On Line:
Selected:
2
Port Selection
Switches Press a switch to access the PC attached to the corresponding port.
• Pressing Port 1 and Port 2 simultaneously for 3 seconds performs a Keyboard/Mouse Reset
• Pressing Port 7 and Port 8 simultaneously starts the Auto Scan Mode
3
Reset Switch
The recessed reset switch can be pressed using a thin object such as a paper clip or ballpoint pen. A
warm reset is initiated when this switch is pressed and released. A cold reset is initiated when this
switch is kept pressed for longer than 3 seconds.
4
Power LED
Lights to indicate that the unit is receiving power.

Rear View:

1
1
Power Jack
The optional power adapter plugs in here. The switch is designed to be non-powered (no external
power required). It draws the necessary power from the connected CPUs through the Keyboard/
Mouse connection. External power is required when units are cascaded, or if the CPUs do not
providing sufficient power (operation will be erratic).
2
Console Port Section
• If this is a single KVM or a first station, your monitor, keyboard and mouse plug in here.
• If this is a second or third level station (cascaded unit), the cables that connect to the upper level
KVM connect here.
3
CPU Port Section
The cables from the PCs plug in here.
4/19/2006
1
2
Lights ORANGE when the attached PC is ON. A flashing LED indicates
that that port is being used as a cascade port and has another KVM Switch
connected to it.
Lights GREEN to indicate which port is currently selected. The LED will
be flashing when the port is being accessed under the Auto Scan Mode.
2
4
1:45 PM Page 4
3 4
3