Seko OPL-ADVANTAGE Manual De Instalación página 19

OPL-ADVANTAGE – OPL system
6.1 Other Features and functions of the OPL Advantage – Quick Reference
Drain Mode - Allows programming based on Drain function. Drain mode requires only one signal Source.
See instruction manual pages 11 & 12
Lockout - Provides the option of preventing unwanted injections if signals are received more than once
during a formula. See instruction manual page 13
Levels - Pumps 1 to 6 will accept two different injection amounts (Level 1 and Level 2) during a formula.
Pump numbers and their corresponding second level are as follows:
1/A;
Level enable/disable allows you to disable the second level injection. This will offset situations
where the load count pump is skipped, either from operator error or machine malfunction,
preventing a missed injection. See instruction manual page 13
Formula enable/disable - These features allows you to display only those formulas you want visible to the
After entering the access code, enter these PUMP/FORMULA commands to program functions:
CHANGING ACCESS CODE
SET SIGNAL LOCKOUT
SELECT DELAY UNITS (Display: 001 for seconds; 060 for minutes)
DRAIN MODE - enable/disable (Display: 001 enable; 000 disable)
DRAIN MODE – inverting signal (Normally Open/Normally Closed)
PUMP LEVELS – enable/disable (Display: 000 enable; 001 disable)
SET RESET TIMER
FLUSH MANIFOLD
FORMULA - enable/disable (Display: 000 enable; 001 disable)
NOTE: This quick reference will help you program most basic OPL applications. For any questions it
is advised that you become familiar with the installation and programming portions of the complete
instruction manual for the OPL Advantage.
OPL-ADVANTAGE
2/B; 3/C; 4/D;
operators. See instruction manual page 14
PUMP/FORMULA - Programming Commands
code 0000136607
5/E; 6/0;
Pump 1 + Formula A
Pump 2 + Formula A
Pump 3 + Formula A
Pump 5 + Formula A
Pump 6 + Formula A
Pump 7 + Formula A
Pump 8 + Formula A
Pump F + Selected
Formula
Number
Pump F + Toggle To
Delay
Mode LED
Flashing
rev. 1.6 EN 17