Akron STYLE 3578 STREAMMASTER Instrucciones De Instalación, Funcionamiento Y Mantenimiento página 18

Figure 4
The elevation stop position and their corresponding stop/plug configurations are shown in the table below. The hole location
for the plug/stop is referred to by an angle from the horizontal. The outlet angle is the angle trajectory (from horizontal) the
water will flow from the StreamMaster unit.
Note that the permanent stop must remain installed. If this stop is removed, the outlet will go past vertical and the gear will run
out of travel .
There are six options for the customer to use . This is achieved with 3 plugs, 1 permanent stop, and 2 stops provided
(the unit will be assembled with the permanent stop in 0° location, 1 stop in the -45°, and plugs in the remaining
15° and -60° locations) .
The parts kit will contain 1 stop and 1 plug .
PS
ELEVATION STOPS
HOLE LOCATION
15° 0° -45°
P PS S
P PS P
S PS P
P PS P
S PS P
S PS S
P=PLUG S=STOP PS=PERMANENT STOP
Factory Set Stops
P
15°
-45°
-60°
S
P
Lower Upper
Outlet Outlet
Angle Angle
-60°
P -45° 45°
S -45° 30°*
P -30° 90°
P -45° 90°
S -30° 30°*
P -30° 45°
16
*-The Stow Function will
not operate properly when
the upper outlet angle is set
to 30° .