Problem
The rechargeable battery
can no longer be charged
or runs empty very fast.
The battery of the remote
control runs empty too
fast.
The robot is moving in
circles.
The robot cannot find the
docking station.
Possible cause
The rechargeable battery has
reached the end of its life.
Perhaps you did not insert
the correct type of battery.
The robot is in spot-cleaning
mode.
There is not enough room for
the robot to navigate towards
the docking station.
The robot is still actively
searching.
Solution
Replace the rechargeable battery (see
chapter 'Replacement').
For the remote control, you need a
CR2025 coin-shaped battery. If the
problem persists, go to
www.philips.com/support or contact the
Consumer Care Center in your country.
This is normal behavior. The spiral mode
can be activated when a lot of dirt is
detected on the floor for a thorough clean.
It is also part of the auto cleaning mode.
After approximately one minute the robot
resumes its normal cleaning pattern. You
can also stop the spiral mode by selecting
a different cleaning mode on the remote
control.
Try to find another place for the docking
station. See 'Installing the docking station'
in chapter 'Preparing for use'.
Give the robot around 20 minutes to
return to the docking station.
English
27