Troubleshooting - KitchenAid KDFE454CSS Instrucciones Para El Usuario

Dishwasher Maintenance Procedure
Cleaning the Dishwasher
Clean the exterior of dishwasher with a soft, damp cloth and mild detergent. If your dishwasher has a stainless steel exterior, a stainless
steel cleaner is recommended - Stainless Steel Cleaner and Polish Part Number 31462A.
Removal of Hard Water / Filming:
Recommended use of a monthly maintenance product such as affresh
Load your dishwasher (preferably with dishes affected by filming / hard water).
Place tablet in main wash compartment of detergent dispenser.
Select cycle/option best for heavily soiled dishes and start dishwasher.
NOTE: Recommended to use a premeasured detergent tablet or pack for regular daily use.
Vacation or Extended Time Without Use
To reduce the risk of property
damage
First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions)
PROBLEM
DISHWASHER DOES
NOT RUN
DETERGENT REMAINS IN
THE DISPENSER OR
TABLET IS ON BOTTOM
OF TUB
CYCLE RUNS TOO LONG
® affresh is a registered trademark of Whirlpool, U.S.A.
16
If you will not be using the dishwasher during the summer months, turn off the water
and power supply to the dishwasher.
Make sure the water supply lines are protected against freezing conditions. Ice
formations in the supply lines can increase water pressure and damage your
dishwasher or home. Damage from freezing is not covered by the warranty.
When storing your dishwasher in the winter, avoid water damage by having your
dishwasher winterized by authorized service personnel.

Troubleshooting

to possibly avoid the cost of a service call.
In the U.S.A., www.kitchenaid.com
SOLUTION
NOTE: It is normal for the dishwasher to repeatedly pause several times during a cycle.
If the Start/Resume light is blinking, close the door and push START/RESUME.
Be sure the door is closed and latched.
Be sure you have disabled Sleep Mode by pressing either START/RESUME or CANCEL, or opening and
closing the door before selecting your cycle/option.
Check that there is not an interference with large casserole dishes and the wash system at the back of
the dishwasher. Adjust loading as necessary to ensure door is closed and latched.
Be sure you have selected a cycle. (See "Cycle and Option Descriptions" section.)
Be sure there is power to the dishwasher. A circuit breaker or fuse may have tripped.
If lights other than Start/Resume blink and the unit will not run, you will need to call for service.
Check for dishware such as cookie sheets, cutting boards, or large containers, etc., that may be
blocking the detergent dispenser from opening properly.
Be sure your detergent is fresh and lump free.
Be sure the cycle has completed (the Clean light is on). If it has not completed, you will need to resume
the cycle by closing the door and pressing START/RESUME.
NOTES:
To use less water and reduce energy consumption you will encounter cycles that typically run for up
to 3 hours.
A water heater setting of 120°F (49°C) is best, the dishwasher will delay longer while heating cooler
water.
Some options will add time to the cycle. (See "Cycle and Option Descriptions" section.) The
ProDry™ or Heat Dry option adds approximately ¹⁄₂ hour.
Try the 1 Hour Wash cycle.
Run the hot water at a faucet close to the dishwasher before starting the cycle.
® Dishwasher Cleaner Part Number W10282479.
In Canada, www.kitchenaid.ca