Tabla de contenido
Optional Laminated Beam
Fig. 23
note: Lay the lumber on a flat surface
before beginning laminated beam assembly.
Fig. 23a
Stagger screws to
note: Attach one end of the beam with one
2-1/2'' screws, screw boards and attach the other
end with three 2-1/2'' screws. This will insure that
your boards will stay aligned throughout the
remainder of the beam assembly.
1. If 4" x 6" lumber is not available, you may
2. Lay the lumber on a flat surface and align all of
3. From the end of each board, measure and place a
4. Assemble the beam by attaching each end
insure a sturdy
bond between
boards
29
P. Laminated Beam Instructions
laminate two 2" x 6" x 144'' pieces of lumber
together to create the beam.
the edges. NOTE: Make sure each piece of
lumber is the same length. If it is not, trim board(s).
mark at 24" intervals (Fig. 23).
together using three 2-1/2'' screws (Fig. 23a).
Note: Stagger the screws as shown in (Fig. 23a). to
insure a sturdy bond. Repeat every 24" along the
entire length of the beam.When beam is complete,
measure, drill holes, and attach beam clamps and
nylon bushing swing hangers
ProJect 512
24"
Tabla de contenido
