14
14 UNIT START UP
Turn on hot and cold water supplies, and check for leaks above and below the sink.
Note: After installation is complete, flush faucet (see step 17).
FAUCET FUNCTIONS
15
15B
15 FAUCET FUNCTION
By lifting the Lever Handle (15A) up, the valve will be activated allowing water to flow.
The water flow will increase by continuing to lift up the Lever Handle (15A). By rotating
the Lever Handle counter-clockwise, the water temperature will decrease to cold flow
only. By rotating the Lever Handle clockwise, the water temperature will increased to
hot flow only.
The Spout (15B) can be rotated around the Faucet Body in any direction.
16
16A
16 SIDE SPRAY OPERATION
The Side Spray (16A) can be pulled forward to spray water in any direction. To activate
the Side Spray, press the Toggle Button (16B) located on the back of the Side Spray (16A).
ON
15A
HOT
15A
COLD
16B
ENGLISH
17
17E
17D
17 FLUSHING & AERATOR CLEANING
After installation is complete, remove Aerator Housing (17A). Turn Valve (17B) on
and allow both hot and cold water to run for at least one minute each. While water is
running, check for leaks. To clean the aerator, disassemble Aerator Housing (17A) by
separating the Aerator Shell (17C), Basket (17D), and Washer (17E). Once parts have
been cleaned, reassemble by reversing steps.
MAINTENANCE & CARE
18
18 HANDLE REMOVAL
Turn off water before proceeding! With valves in closed position, detach Decorative
Button (18A), unscrew Fastener (18B), and remove Handle Hub (18C) from Valve Stem (18D).
19
19 CARTRIDGE REMOVAL
Turn off water supplies and relieve pressure before working on your faucet (see step 2). Remove
Handle (See step 18) Remove the Dome Cap (19A) by unscrewing it in a counterclockwise
direction. Using an adjustable wrench, unscrew the Retainer Ring (19B). Carefully remove the
Cartridge (19C) by pulling it straight up and out. Inspect Cartridge (19C) for debris or damage.
Clean or replace the Cartridge (19C). Reassemble faucet by reversing steps.
5
17B
17A
17C
18B
19A
19B
19C
18A
18C
18D