Maintenance - GE JGS750EEFES Manual Del Propietário

Maintenance

Oven Light Replacement
SHOCK OR BURN HAZARD:
WARNING
oven at the main fuse or circuit breaker panel. Failure to do so may result in electric shock or burn.
BURN HAZARD: The glass cover and bulb should be removed when cool. Touching hot glass with
CAUTION
bare hands or a damp cloth can cause burns.
NOTE: The glass cover should be removed only when
cold. Wearing latex gloves may offer a better grip.
the oven at the main fuse or circuit breaker panel. Let
the bulb cool completely before removing it. For your
safety do not touch a hot bulb with a damp cloth. If you
do the bulb may break.
To remove:
tabs of the glass cover clear the grooves of the socket.
Remove the bulb.
To replace:
the glass cover into the grooves of the socket. Turn the
Lift-Off Oven Door
To Remove the Door:
frame to the unlocked position.
4. Close door until the top of the door is approximately
arms are clear of the slots in the range frame.
To Replace the Door:
position, rest the notch on the underside of the left
hinge arm on the bottom edge of the left hinge slot.
The notch in the hinge arm must be fully seated into
the bottom of the slot. Repeat for the right side.
notches in the bottoms of the hinge arms have not
seated correctly in the bottom edge of the slot. Lift the
door off the range and repeat previous step.
4. Push the hinge locks toward the range cavity and
down to the locked position.
28
NOTE:
is smaller than a standard
Reconnect electrical power
to the oven once the new
bulb is installed.
For improved lighting inside
the oven, clean the glass
cover frequently using a
wet cloth. This should be
done when the oven is
completely cool.
Pull hinge locks up to unlock
Hinge arm
Bottom
edge of
slot
Notch
Rest notch on bottom edge
of hinge slot
Socket
3 "
1 2
Max
length
Bulb
Tab
Glass cover
Removal position
Push hinge locks down to lock
49-85211-6