Charging The Batteries; Preliminary Procedures; Machine Working Hour Check - Advance Adfinity 17ST Instrucciones De Uso

CHARGING THE BATTERIES

NOTE
Charge the batteries when the yellow or red warning led (81b or 81c) turns on, or at the end of every working cycle.
CAUTION!
Keeping the batteries charged make their life last longer.
CAUTION!
When the batteries are discharged, charge them as soon as possible, as that condition makes their life shorter.
Check for battery charge at least once a week.
WARNING!
WET battery charging produces highly explosive hydrogen gas. Charge the batteries in well-ventilated areas and
away from bare fl ames. Do not smoke while charging the batteries.
Keep the tank assembly open while charging the batteries.
WARNING!
Pay careful attention when charging the batteries as there may be battery fl uid leakages. The battery fl uid is
corrosive. If it comes in contact with skin or eyes, rinse thoroughly with water and consult a physician.

Preliminary procedures

1. Open the cover (22) and check that the recovery water tank (21) is empty, otherwise empty it with the drain hose (16).
2. Drive the machine to the appointed recharging area.
3. (Only for Adfi nity™ X20R): Turn the ignition key (80) to "0".
(Only for Adfi nity™ 17ST - 20ST): Press the switch (71) and/or (73) to turn the machine off.
4. Grasp the handle (41) and carefully lift the tank (40).
5. For WET batteries only:
• Check the level of electrolyte inside the batteries (53); if necessary, top up through the caps (54).
• Then leave all the caps (54) open for battery charging.
• If necessary, clean the upper surface of the batteries.
6. Charge the batteries according to one of the following procedures, depending on the presence of the battery charger (90).
Battery charging
7. Connect the battery charger cable (6) to the electrical mains (the electrical mains voltage and frequency must be compatible
with the battery charger values shown on the machine serial number plate (34)).
When the battery charger is connected to the electrical mains, all machine functions are automatically cut off.
If the red warning led (94) on the battery charger control panel stays on, the battery charger is charging the batteries.
8. When the green warning led (92) turns on, the battery charging is completed.
9. When the battery charging is completed, disconnect the battery charger cable (6) from the electrical mains and wind it round
its housing (7).
10. Grasp the handle (41) and carefully lower the tank (40).
NOTE
For further information about the operation of the battery charger (90), see the relevant Manual.

MACHINE WORKING HOUR CHECK

(Only if the machine is equipped with hour counter)
1. (Only for Adfi nity™ X20R): Turn the ignition key (80) to "I".
2. Press the switch (73) and read on the hour counter (75) the total number of working hours (scrubbing/drying) performed by the
machine.
3. Press the switch (73) again.
4. (Only for Adfi nity™ X20R): Turn the ignition key (80) to "0".
Adfi nity™ 17ST - 20ST - X20R
INSTRUCTION FOR USE
9096912000(4)2010-11
ENGLISH
19