Start-Up - GOK SmartBox 1 Instrucciones Par El Montaje Y La Operación

START-UP

Operation elements and display
The device is adjusted once when it is put into operation. After start-up the device operates in
display mode with the top closed.
From device version V4.xx the display is a two-line LCD display with 2 x 16 characters.
The display has green background lighting for best readability in all lighting conditions.
®
SmartBox 1, 2 and 3 has the following display:
Before programming, you need to ascertain the tank data and enter the values into the right
column input value of the following table. Then, enter the values for the individual entry steps.
Optionally, the device can also be programmed as explained in the enclosed Quick Guide.
Setting a
parameter:
Quitting the
setup mode:
4 / 16
Press [Enter] to open setup mode.
Select the desired setting parameter via PLUS [+].
Press [Enter] to call up the value selection for the parameter.
Set the value with MINUS [-] / PLUS [+], press [Enter] to save.
You can quit the setup mode at any time.
Select "8.Exit" and press [Enter]
 to go back to the standard display mode.
®
SmartBox 1 / SmartBox
The device is adjusted via the three small
blue buttons:
Select the language (German, English or
French) in menu step 18.Language (see
page 11).
After the level indicator has been installed, it
can be started up.
®
2 / SmartBox
These are located on the
motherboard between the
terminals.
Part No. 28 100 57 e
®
3