Idiomas disponibles
Idiomas disponibles
If Lead Sheath Cable
Solder ground braid(s) or bonding wire on to lead sheath. Deburr
connection. Discard spring clamps, connectors, and foil tape.
Go to Step 17.
17. Install the shielding mesh
Wrap a half-lapped layer of the mesh across the entire splice and tie
off.
Abrade and solvent clean cable jackets as shown to provide an oil-
free surface.
18. Position wraparound sleeve
Remove or tape over all sharp points to prevent puncture of
wraparound sleeve. Remove backing from the wraparound sealing
sleeve and center sleeve over splice. Slide metal channels onto the
butted rails.
19. Install channel clip
If two channels are used, connect the channels with the short
channel retention clip. Use pliers to install clip.
Note: Channel(s) must overlap sleeve edge by 1/4 inch (5mm)
minimum.
20. Shrink the wraparound sleeve
Begin at the center and work toward each end. Post heat the entire
sleeve (concentrating on metal channel area) for 30 seconds after
completely shrunk.
This completes the splice.
Note: Allow to cool before moving or placing in service.
The Information contained in these installation instructions is for use only by installers trained to make electrical power installations and is intended to describe the correct method
of installation for this product. However, Tyco Electronics Corporation has no control over the field conditions which influence product installation. It is the user's responsibility to
determine the suitability of the installation method in the user's field conditions. Tyco Electronics' only obligations are those in Tyco Electronics' standard Conditions of Sale for this
product and in no case will Tyco Electronics be liable for any other incidental, indirect or consequential damages arising from the use or misuse of the products.
TE (logo) and Tyco Electronics are trademarks. Copyright 2006, 2010 Tyco Electronics Corporation. All Rights Reserved.
PII 53105
Revision AK
Choice 3
Clean
Shielding Mesh
8"
(200mm)
Black/Red Triple Layer Tube
Black Wraparound Sleeve
1/4" min.
(5mm)
Adhesive Flow (Both Ends)
6
121
Clean
8"
(200mm)
124
Metal Channel
125
Channel
Clip
1/4" min.
(5mm)
126
Torch
127
PCN 625799-000
Effective Date: June 17, 2010
