Idiomas disponibles
Idiomas disponibles
15. Center red/black triple layer tube; shrink in place
Center the tube over the splice. Begin shrinking at the center (1) of
the tube, working the torch around all sides of the tube. After the
center portion shrinks, work towards one end (2), then to the opposite
end (3).
Note: Do not point the flame at the cable semi-con.
Note: Pay particular attention to the hard to reach parts, especially
the back and underside of the tube. The tube should have a smooth
and even surface when finished.
Post heat the entire tube for 1 minute after fully shrunk.
Note: If External Grounding or Shield Interrupting
Refer to Raychem HVS-EG, "Guide for External Grounding and Shield
Interrupting of Power Cable Splices" for modifications to these
instructions.
16. Install ground
Choose the appropriate cable type (Choice 1-3) and follow the
directions given.
If Drain Wire or UniShield Cable
Pigtail the shield wires on each side. Crimp the ground braid onto
one pigtail with the connector provided.
Lay braid across splice tubes and attach to pigtail on the other side.
Cut off excess braid and trim pig-tailed wires.
Discard spring clamps and foil tape.
Go to Step 17.
If Metallic Tape Shield Cable
(1) Flare one end of the ground braid and place it onto the metallic
tape butted up to the installed splice tubes. (2) Attach the braid to the
shield by placing two wraps of the spring clamp over the braid. (3)
Fold the braid back over the spring clamp wraps. Continue to wrap
the remaining clamp over the braid. Tighten clamp by twisting it in the
direction it is wrapped and secure with copper foil tape provided.
(4) Lay the braid across the splice tube and onto the exposed tape
shield on the other side. (5) Make two wraps of the clamp over the
braid. (6) Fold the braid back toward the splice and finish wrapping
the clamp. Tighten and secure. Cut off excess braid.
Discard connectors.
Go to Step 17.
PII 53105
Revision AK
Choice 1
Choice 2
2
Red/Black Triple Layer Tube
between jacket cutbacks
5
Torch
3
1
1
Center tube
PCN 625799-000
Effective Date: June 17, 2010
607
120
122
123
