Jun-Air 1000 motor Modo De Empleo página 4

Safety
Important - read this first!
Please read the following information and operating instructions
included with this product before use. This information is for your
safety and it is important that you follow these instructions. It
will also help prevent damage to the product. Failure to operate
the unit in accordance with the instructions or using JUN-AIR
unauthorized spare parts can cause damage to the unit and
could cause serious injury.
IMPORTANT: General directions for installation
• If the compressor is not fitted with a supply plug a circuit
breaker must be incorporated in the fixed wiring.
• If this unit is supplied with a three-pin plug, connect with a
properly earthed outlet only.
CAUTION: To reduce risk of electric shock
• Only authorized service agents should carry out service.
Removing parts or attempting repairs can create an electric
shock. Refer all servicing to qualified service agents.
WARNING: To reduce risk of electrocution
• Do not use this unit with electrical voltages other than
stated on the rating plate.
• Always unplug this unit immediately after use and store in a
dry place.
• Do not use this product in or near liquid or where it can fall
or be pulled into water or other liquids.
• Do not reach for this product if it has fallen into liquid.
Unplug immediately.
• This unit is not weatherproof. Never operate outdoors in the
rain or in a wet area.
DANGER: To reduce risk of explosion or fire
• During spraying with combustible liquids risk of explosion
may arise, particularly in closed rooms
• Do not use this product in or near explosive atmospheres or
where aerosol products are being used.
• Do not pump any other gases other than atmospheric air.
• Do not pump combustible liquids or vapours with this
product; do not use it in or near areas with combustible or
explosive liquids or vapours.
• Do not use this unit near naked flames.
4
CAUTION: To prevent injury
• Compressed air can be dangerous; do not direct airflow at a
persons head or body.
• Always keep the compressor out of reach of children.
• Never operate this product if it has a damaged power lead
or plug, if it has been dropped or damaged, or if it has
fallen into water. Return the product to a service centre for
examination and repair.
• Keep the electrical cable away from hot surfaces.
• Ensure all openings are kept free of restriction and never
place the motor on a soft surface where the openings may
be blocked. Keep all openings free from dust, dirt and other
particles.
• Never leave this product unattended when plugged in.
• Never insert fingers or any other objects into fans.
• This unit is thermally protected and can automatically
restart when the overload resets.
• Wear safety glasses, when servicing this product.
• Use only in well ventilated areas.
• This product may only be connected to units or tools with a
max. pressure higher or equal to that of the compressor.
• The surface of the compressor can get hot. Do not touch
compressor motor during operation.
Failure to observe the above safety precautions could result in
severe bodily injury, including death in extreme cases.
IMPORTANT: General directions for use
• Protect compressor against rain, moisture, frost and dust.
• The compressor is constructed and approved for a max.
pressure as stated under Technical Specifications.
• Do not operate compressor at ambient temperatures
exceeding 40°C/104°F or falling below 0°C/32°F.
• If the supply lead on the compressor is defective, an
authorized JUN-AIR distributor or other qualified personnel
must carry out the repair.