Assembly - Powermate PFTT142.1 Manual De Operación

Assembly

• Save all instructions
Read and follow the assembly instructions . Do not discard
any parts or materials until the unit is assembled .
References to the right or left side of the tiller are from the
viewpoint of the operator's position behind the tiller.
WARNING
Do not operate tiller if it is damaged or not completely and
correctly assembled .
WARNING
Before doing any assembly or maintenance to the unit,
remove the wire from the spark plug .
WARNING
Always wear ANSI compliant safety glasses with side
shields while assembling the tiller .
A
How to Remove Tiller from Carton
1 . Remove all parts and packaging components .
2 . Use a utility knife to cut all 4 vertical edges and lay the
side panels flat around the tiller .
B
Assembly Instructions
The tiller comes assembled except for a few parts . The
following instructions will help you complete the tiller assembly .
Attach the wheel assembly to the frame
1 . Install the wheel assembly to the frame by removing
a hairpin cotter and flat washer from one end of pivot
rod . Remove rod from frame . Align pivot holes in
wheel assembly to pivot holes in frame . Install pivot rod
and secure by reinstalling flat washer and hairpin.
(See Figure 2)
Questions? Call Toll Free at 1-800-737-2112
If you need assistance or find any parts missing,
CALL TOLL FREE: 1-800-737-2112.
The following components will be found in the carton .
Quantities shown in ( ) .
1 . (1) Tiller
2 . (1) Upper Handle Assembly
3 . (1) Lower Handle
4 . (4) Tines
5 . (1) Wheel Assembly
6 . (1) Drag bar
7 . (2) Outside Tine Shields
8. (1) Tiller Operator's Manual
9 . (1) Engine Manual
10 . (1) Bottle of Engine Oil
11 . (1) Parts bag containing the following
a . (4) M10 x 25 mm bolts, flat washers and lock washers
for assembling lower handle .
b . (4) M8 x 25 mm saddle bolts and flat washers for as-
sembling upper handle to lower handle .
c . (4) Handle knobs, for upper handle to lower handle .
d . (2) Lynch pins for assembling outer tines .
e . (2) M10 x 50 mm bolts, (4) flat washers and (2) M10
locknuts for assembling inner tines .
f . (1) Pin, flat washer and hairpin cotter for drag bar .
g . (6) M6 x 16 bolts, lock nuts, and flat washers for install-
ing outside tine shields .
h . (1) Rope guide with nylock nut .
i . (1) Cable Ties .
3 . Remove any remaining packaging .
ENG - 8
Copyright © 2018 MAT Engine Technologies, LLC
Figure 2