JENN-AIR JGC6430 Guia Del Usuario página 7

C
& C
ARE
CAUTION
• Be sure appliance is off and all
parts are cool before handling
or cleaning. This is to avoid
damage and possible burns.
• To prevent staining or discoloration,
clean appliance after each use.
• If a part is removed, be sure it is
correctly replaced.
B C S
URNER APS AND
G B
AS URNERS
Removable Burner Caps
• Allow burner to cool. Remove burner cap
and wash in soapy water with a plastic scouring pad. For stubborn soils, clean
with a soap-filled, nonabrasive pad or
Cooktop Cleaning Creme (Part
#20000001)** and a sponge.
• Do not clean in dishwasher or self-
cleaning oven.
Sealed Gas Burner
• Clean frequently. Allow burner to cool.
Clean with soap and plastic scouring pad.
For stubborn soils, clean with a soap-
filled, nonabrasive pad.
• Be careful not to get water into the center
of the burner.
• Use care when cleaning the ignitor. If the
ignitor is wet or damaged the surface
burner will not light.
• To ensure even cooking performance,
keep burner ports free of food soils/
debris.
B G - P
URNER RATES
C I
AST RON
• Wash grates with warm, soapy water and
a nonabrasive, plastic scrubbing pad. For
stubborn soils, clean with a soap-filled,
nonabrasive pad or Cooktop Cleaning
Creme (Part #20000001)** and a sponge.
If soil remains, reapply Cooktop Cleaning
Creme, cover with a damp paper towel
and soak for 30 minutes. Scrub again,
rinse and dry.
• Do not clean in dishwasher or self-
cleaning oven.
* Brand names for cleaning products are registered trademarks of the respective manufacturers.
** To order direct, call 1-800-JENNAIR (1-800-536-6247).
LEANING
C
ONTROL
• Remove knobs in the OFF position by
pulling up.
• Wash, rinse and dry. Do not use abrasive
cleaning agents as they may scratch the
finish.
• Turn on each burner to be sure the
knobs have been correctly replaced.
C
OOKTOP
Porcelain enamel is glass fused on metal
and may crack or chip with misuse. It is
EALED
acid resistant, not acid proof. All spillovers,
especially acidic or sugary spillovers,
should be wiped up immediately with a dry
cloth.
• When cool, wash with soapy water, rinse
and dry.
• Never wipe off a warm or hot surface
with a damp cloth. This may cause
cracking or chipping.
• Never use oven cleaners, abrasive or
caustic cleaning agents on exterior finish
of range.
C
OOKTOP
(
SELECT MODELS
• DO NOT USE ANY CLEANING PROD-
UCT CONTAINING CHLORINE
BLEACH.
• ALWAYS WIPE WITH THE GRAIN
WHEN CLEANING.
• Daily Cleaning/Light Soil –– Wipe with
one of the following - soapy water, white
vinegar/water solution, Formula 409
Glass and Surface Cleaner* or a similar
glass cleaner - using a sponge or soft
ORCELAIN ON
cloth. Rinse and dry. To polish and help
prevent fingerprints, follow with Stainless
Steel Magic Spray (Jenn-Air Model A912,
Part No. 20000008)**.
• Moderate/Heavy Soil –– Wipe with
one of the following - Bon Ami*, Smart
Cleanser*, or Soft Scrub* - using a damp
sponge or soft cloth. Rinse and dry.
Stubborn soils may be removed with a
damp Scotch-Brite* pad; rub evenly with
the grain. Rinse and dry. To restore luster
and remove streaks, follow with Stainless
Steel Magic Spray.
K
NOBS
- P E
ORCELAIN NAMEL
- S S
TAINLESS TEEL
)
6
• Discoloration –– Using a damp sponge or
soft cloth, wipe with Cameo Stainless Steel
Cleaner*. Rinse immediately and dry. To
remove streaks and restore luster, follow
with Stainless Steel Magic Spray.
B
Y
EFORE
C S
ALL FOR
S
URFACE BURNER FAILS TO LIGHT
• Check to be sure plug is securely inserted
into receptacle.
• Check or re-set circuit breaker. Check or
replace fuse.
• Check power supply.
• Check to be sure burner is correctly rated
for your kind of gas.
• Check to be sure burner ports or ignition
ports are not clogged.
• Check to be sure ignitor is dry and
clicking. Burner will not light if ignitor is
damaged, soiled or wet. If ignitor doesn't
click, turn control knob OFF.
• Check to be sure burner cap is correctly
seated on the burner base.
• Check that the gas is turned on.
S
URFACE BURNER FLAME LIFTS
.
OFF PORTS
• Check to be sure a pan is sitting on the
grate above.
• Contact an authorized Jenn-Air servicer.
T
HE FLAME IS UNEVEN
• Burner ports may be clogged.
• Flame may need to be adjusted. Contact
an authorized Jenn-Air servicer.
S
URFACE BURNER FLAME IS
.
YELLOW IN COLOR
• Contact an authorized Jenn-Air servicer.
• Some yellow tips on the flame are
acceptable when using LP gas.
OU
ERVICE
.
.