Display; Status Display - Resol Datalogger DL3 Manual Abreviado

If more than one item of several can be selected, they will be indicated with check-
boxes. When an item has been selected, an x appears inside the checkbox.
5.4

Display

During normal operation, the DL3 Datalogger indicates the status display (see fig.
27). buttons  and  can be used to switch between the displays.
If no button has been pressed within a couple of minutes, the display illumination
is switched off.
Î Press any key to reactivate the display illumination.

5.4.1 Status display

During normal operation, the DL3 Datalogger indicates the status display with the
following information:
• Data memory progress bar (fill level)
• Remaining logging time in days
• VBus devices connected
®
• Sensors connected
The data memory progress bar is divided into 10 segments. Each segment repre-
sents 10 % of the memory capacity.
Data memory progress bar
• Segment filled: The memory capacity of this segment is fully occupied.
• Segment flashing: The memory capacity of this segment is partly occupied.
The arrow above the data memory progress bar indicates the remaining logging
time in days.
In the bottom left-hand area of the status display, each VBus
a functioning VBus ® communication is indicated by a corresponding filled checkbox.
In the bottom right-hand area of the status display, each sensor connected is indi-
cated by a corresponding filled checkbox.
5.4.2 Network display
In the network display, information about the network connection is displayed.
In the centre, the IP address of the DL3 is displayed. When the DL3 is connected
to the Local Area Network (LAN), a house is indicated on the left-hand side of
the display.
When the DL3 is also connected to the Internet, a globe is indicated on the right-
hand side of the display (the house is not indicated any more in that case).
If the DL3 has not been assigned with an IP address, none of the symbols are indicated,
the line remains empty.
Note:
If a static IP address has been assigned to the DL3, the IP address and the house/
globe symbol appear as soon as the network cable has been connected.
device connected with
®
27