Troubleshooting - Vollrath Mirage Drop-in Manual Del Operador

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING

Problem
The equipment is on, but not heating
and the display is flashing.
Alarm is sounding.
The equipment suddenly stopped
working.
Display
Message Cause
The inset is not a Vollrath induction-ready inset or is the wrong size
Bad Pan
Vollrath induction-ready inset.
If the equipment is turned off, this is normal. It indicates the
equipment is still hot.
HOT
If the equipment is in use, the inset may be too hot.
F-2
The inset may be too hot.
F-1
The equipment may have overheated.
F-8
Other error
Internal error.
codes
6
Might be Caused By
The inset is not a Vollrath induction-ready
inset or is the wrong size Vollrath induction-
ready inset.
Trouble with the electrical connection is
causing low input voltage.
An error.
The equipment may be too close to an
external heat source or the air intake may be
restricted.
The inset may be too hot.
®
Mirage
Drop-in Induction Warmers and Rethermalizers Operator's Manual
Course of Action
Replace the inset with the correct size Vollrath induction-ready
inset for the equipment. Vollrath induction-ready insets are
stamped "Induction Ready." Reset the equipment by turning it
OFF and then ON.
Make sure the plug is fully inserted into an electrical outlet that
matches the rating on the equipment's nameplate.
Make sure the electrical circuit is not overloaded.
See the Display Messages in the table below.
Relocate the equipment away from external heat sources. Clear
any obstructions to the air intake. Contact Vollrath Technical
Services if the problem persists.
Remove the inset. Allow the inset and equipment to cool before
resuming use. Contact Vollrath Technical Services if the
problem persists.
Course of Action
Replace the inset with the correct size Vollrath induction-ready
inset for the equipment. Vollrath induction-ready insets are
stamped "Induction Ready." Reset the equipment by turning it
OFF and then ON.
Allow the equipment to cool (about 5-10 minutes) before
cleaning.
Remove the inset. Allow the inset and equipment to cool before
resuming use. Do not place excessively hot food into the inset.
Do not an place excessively hot inset into the equipment.
Contact Vollrath Technical Services if the problem persists.
Remove the inset. Allow the inset and equipment to cool before
resuming use. Do not place excessively hot food into the inset.
Do not an place excessively hot inset into the equipment.
Contact Vollrath Technical Services if the problem persists.
Relocate the equipment away from external heat sources. Clear
any obstructions to the air intake. Contact Vollrath Technical
Services if the problem persists.
Contact Vollrath Technical Services.
Tabla de contenido
loading

Tabla de contenido