Installing The Pump; Flushing The Pump - Binks 0114-016068 Manual Del Usuario

INSTALLING THE PUMP

The 0114-016068 may be installed using a wall, cart, or tripod mount. See the "Comet 4/12 Options" section of this part
sheet for available outfits. Overall dimensions of the pump are as shown below.
PUMP LUBRICATION NOTE
The upper pump (u-cup) seals in the Comet 4/12 Pump
fluid section are designed to resist wear even if the pump is
run dry. Supplemental lubrication is not required.
However, use of a compatible solvent or Binks Wet Sol
Plus (P/N 863009) packing lubricant can be used in the
solvent cup if required by your preventative maintenance
program.
GROUNDING THE PUMP
The grounding wire may be attached to the air motor base
or, if used, the optional high pressure filter. Locations for
the grounding screw are shown below.
Affix ground wire to the air motor base or optional high
pressure filter— see ground screw locations above. Grounding
screw and wire are included with Comet 4/12 Bare Pump.
Affix other end of ground wire to a true earth ground.

FLUSHING THE PUMP

The Comet 4/12 Bare Pump was built to exacting standards and tested with a light weight oil prior to shipment. Flush the
pump with a solvent that is compatible with the material to be sprayed to remove the oil from the pump before using the
pump for the first time.
SERVICING THE PUMP
Remove Pump from service
1. Disconnect air line from air motor inlet.
2. Make sure that all pressure is relieved from the pump.
Trigger gun into a receptacle to remove any residual
3. Slowly disconnect fluid hose from the fluid outlet of the pressure.
unit. If any pressure remains in the system, slowly
loosing the hose fitting will allow the material to drain
out. Catch any material in a receptacle.
4
Binks 4/12 BARE PUMP ASSSEMBLY
4. Remove the siphon hose assembly from the fluid inlet.
5. Loosen the fluid outlet junction locknut (57) and remove
6. Remove the air control and optional filter, if used.
7. Use a 13 mm wrench to remove the tie rod locknuts (55).
8. Hold the air motor up, and, using a 10 mm wrench,
9. Remove the pump rod locking clip (3).
10. Use a 13 mm wrench to separate the air motor shaft
4-3/4
23-1/4
10
the pump assembly from its mounting fixture.
remove the tie rods (46) from the base of the air motor.
from the fluid section shaft.
Solvent Cup