Service Information - BLACK&DECKER LST136 Manual De Instrucciones

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

TROUBLE SHOOTING CONTINUED

PROBLEM

Overfeeding

Line unravels when cap or spool

is removed.

SOLUTION

• Remove the spool and unwind

the cutting line, then wind it on

neatly again. Replace the spool

into the housing.

• Ensure you are cutting with

the tip of the line (7 inches

(177.8mm) from the spool).

Use the edge guide if needed to

ensure proper space is

maintained.

• Ensure you are not

exceeding a 10° angle as

shown in figure N1.

• Make sure to park the lines in

holding slots (S2) figure S

before removing.

IMPORTANT: To assure product SAFETY and RELIABILITY,

repairs, maintenance and adjustment should be performed by

authorized service centers or other qualified service organizations,

always using identical replacement parts.

This device complies with part 15 of the FCC rules. Operation is

subject to the following two conditions: (1) This device may not

cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause

undesired operation.

NOTE: This equipment has been tested and found to comply with

the limits for a Class B digital device, pursuant to Part 15 of the

FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference

will not occur in a particular installation.

If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications to this unit not expressly approved by the

party responsible for compliance could void the user's authority to

operate the equipment. This Class B digital apparatus complies

with Canadian ICES-003.