Electrical Connections - Franklin Electric Little GIANT APA-05-HAR Manual Del Usuario

Electrical Connections

W A R N I N G
s
NOTICE
!
electrician in accordance with national and local codes.
s
WARNING
!
source before attempting to install, service or remove any component. If the power disconnect is out-of-sight, lock it in the
open position and tag it to prevent unexpected application of power.
s
WARNING
!
property damage if ignored, be certain that this product is connected to a circuit equipped with a ground fault circuit
interrupter (GFCI) device. Comply with all national and local electrical and plumbing codes when installing this unit.
Do not use extension cord.
Step 1
Unit Wiring
s
WARNING
!
grounding-type attachment plug. To reduce the risk of electrical shock, be certain that it is connected to a properly grounded
grounding-type receptacle. Disconnect power before working on or around the product.
s
CAUTION
!
a)
and continuously once connected with the proper electrical power.
s
WARNING
!
b)
c) For protection against wet environments, connect power cord only to an outdoor rated receptacle (with cover)
that complies with all applicable national, state, and local codes.
d) Secure (i.e. strain relieve) the power cord at the electrical service post in a manner that complies with national
and local electrical and plumbing codes as well as the National Electrical Code (NEC).
e) Line voltage:
i. Check product nameplate label for proper voltage required. Do not connect to voltage other than that shown on
product nameplate label.
ii. Connect power cord to line voltage specified on motor and nameplate.
iii. If application requires the power cord to be hardwired, wiring is as follows:
Green (or green/yellow)—ground. Black (or brown)—line. White (or blue)—neutral.
f) An unprotected power cord, running from water's edge to receptacle, will be susceptible to damage.
It is recommended the cord be protected inside a conduit which meets all national, state, and local codes.
Step 2
Product is now ready for System Operation Testing. Proceed to Operation Testing section.
8
s
WARNING
!
qualified personnel. Comply with national and local electrical and plumbing codes as well as
the National Electrical Code (NEC) and the Occupational Safety and Health Act (OSHA) when
installing this unit. Failure to install it in compliance with national and local electrical and
plumbing codes and within Franklin Electric recommendations may result in electrical shock
or fire hazard, unsatisfactory performance or equipment failure. Installation information is
available through pump manufacturers and distributors, or directly from Franklin Electric at
our toll free number 888.956.0000.
Installation of the electrical supply circuit to the unit is to be done by a certified licensed
RISK OF ELECTRIC SHOCK - Make certain that the unit is disconnected from the power
To reduce risk of electric shock which can result in personal injury, death or major
RISK OF ELECTRIC SHOCK - This product is supplied with a grounding conductor and/or
The pump is not equipped with an on/off switch. The pump will operate immediately
Possible cutting hazard. Rotating propeller could result in serious injury.
This equipment should be installed by technically