5- Possible Positions Of The Bracket - Elvox EKKO EAM2 Manual Para El Conexionado Y El Uso

EKKO
Before installing the automation, check that:
- the hinges are sturdy and efficient and there is no strong friction
- the measurement Y is no greater than the value shown in the table of installation dimensions. In this case it is necessary to work on the pillar in order to
reach this measurement
- the length of the gear motor power supply cables does not exceed 15 metres
- there are the mechanical stops which are properly secured
Installation dimensions:
F1
Possible positions of the bracket:
Choice of the hole for securing the pivot for actuator rotation:
N.B. If using hole F2 or F3, it is necessary to cut the bracket, see figure:
10
A
Z1
F1
L
F2
E
Z2
F2
F3
F3
Z3
EN