5 - Basic Set-up Examples
Requirement
Change the Load Impedance
Press the soft-key labelled Load
•
Press the soft-key labelled Load again to change the load impedance to High-z (high
•
impedance).
The default load impedance is 50 Ohms, but that this could be changed to any impedance between
50 and 10,000 Ohms. Levels are calculated based upon this impedance.
Successive presses of the Load key alternates between a numeric value and High-z.
Note that the amplitude readout increases to 2 volts pk-pk.
Press the soft-key labelled Load to return the load impedance to 50 Ohms.
•
30
TGF4000 Series Quick Start Guide