How To Assemble And Use - Sunbeam 4182 Manual Del Usuario

your blender
Your Blender
After unpacking the blender, wash everything except
the blender base in warm, soapy water. Dry
thoroughly. Do not place in dishwasher. Wipe the
blender base with a damp cloth or sponge. Do not
immerse the base in water. Care should be taken
when handling the blades, as they are very sharp.

How to Assemble and Use

Important: Your blender jar and cutting blades are
subject to wear during normal use. Always inspect
cutting blades for broken, cracked or loose blades. If
jar or cutting blades are damaged, do not use. Call
our toll-free customer service number to obtain
replacement parts.
• Make sure blender is unplugged. Place blender
base on clean, dry surface to keep foreign
particles from being pulled up into motor during
operation.
• Make sure gasket is in place on outer rim of
blade assembly. The gasket must lie flat. Screw
the blade assembly counterclockwise into the jar
base firmly using the finger tabs on the bottom of
blade assembly.
• To easily assemble into the jar, tilt the blade
assembly slightly and enter with the serrated
blade that curves up. Move as needed to clear the
remaining blades. When seated properly, turn the
blade assembly counterclockwise to tighten. To
remove, just reverse the process; turn the blade
assembly clockwise and lower slightly and in the
direction of the serrated blade tilt up and the
other blades will clear the jar bottom opening.
F 1
IGURE
• NOTE: The blade assembly will turn counter
clockwise to tighten and clockwise to loosen.
• The transparent filler-cap is designed to assist in
tightening and loosening the blade assembly if
necessary.
• Remove the filler-cap from its position in the jar
lid and note the notches in the bottom (open)
end. These notches or slots engage the ribs on the
3
F 2
IGURE
F 1
IGURE
F 2
IGURE