Electrical Connection - CORBERO CCH108W Instrucciones Para A Su Uso Y Mantenimiento

R600a (ISOBUTANE)
Isobutane is a natural gas that doesn't affect the environment, but it is inflammable. Before con-
necting the equipment to the mains, it is therefore indispensable to check that the cooling circuit
tubing is not damaged. For every 8 grams of cooling fluid, there must be a minimum of 1 cubic metre of
space in the room where the appliance is installed. In the event of a leakage of cooling fluid, make sure
that no flames or other sources of ignition are allowed to get near the leakage point.
INSTALLATION
The equipment must be installed by two people in order to avoid damage to persons and
things. If the equipment has suffered damage
during transport, immediately inform the supplier before
connecting up. Wait at least two hours after installation
before putting the appliance into operation, to allow the
cooling fluid to reach optimum efficiency. The equip-
ment must be put in a dry, well ventilated place. It must
be installed on a flat, stable surface. Adjust the levelling
feet if necessary. There must be at least 90 mm space be-
tween the back of the equipment and the wall (Fig. 1).
Any shelving or cupboards over the appliance must be at
least 800 mm from the cover. Ambient temperature con-
siderably affects energy consumption, so the equipment
shouldn't be exposed to direct sunlight or placed next to
heat sources such as heaters, stoves, cookers, etc. Check
the climate classification on technical data plate on the
back of the equipment.
(operates at ambient temperatures between) +10° C and +32° C
''SN ''
''N '' (operates at ambient temperatures between) +16° C and +32° C
(operates at ambient temperatures between) +16° C and +38° C
''ST ''
''T '' (operates at ambient temperatures between) +16° C and +43° C
Important:
Make sure there is easy access to the power outlet so that the plug can be removed when necessary. If this
isn't possible, connect the equipment to the mains by means of a bipolar switch, in an accessible position,
with a contact opening of at least 3 mm.

ELECTRICAL CONNECTION

Connection of the equipment to a power outlet with an earth contact is a legal requirement. For this
reason the equipment is fitted with a plug with an earth wire for connection to an outlet of the same
type. The manufacturer declines any liability for damage to persons, property or pets due to failure
to observe this rule. Check that the voltage indicated on the technical data plate on the back of the
equipment is the same as that of your mains supply.
How to replace the lamp (only for appliances with lamp) Unplug the equipment or switch off at the main
power switch before replacing the lamp. Only use lamps of the wattage indicated on the lamp shield
(eg. max. 15 W).
(Fig. 1).
- 3 -
9 cm
20 cm