Timer Operation; Installation - Toshiba MCY-MAP0367HS-UL El Manual Del Propietario

5

Timer operation

• Three timer modes are available: (Setting of up to 168 hours is enabled.)
OFF timer : The unit stops when the set time is reached.
Repeat OFF timer : The unit stops daily when the set time is reached.
ON timer : The unit starts when the set time is reached.
 Timer operation
1
3
Set
1
Push button.
The Timer mode changes each time the button is
pushed.
OFF OFF ON
(OFF timer) (Repeat OFF timer) (ON timer)
No display
• and timer display flashes.
2
Push to select "set time".
• With every push of button, the set time
increases by 0.5 hr (30 minutes).
When setting a time more than 24 hours for
timer operation, the timer can be set in
increments of 1 hr.
The maximum set time is 168hr (7 days).
The remote control displays the set time with
time (between 0.5 and 23.5 hours) (*
number of days and time (24 hours or more) (*
as shown below.
• With every push of button, the set time
decreases by 0.5 hr (30 minutes) (0.5 -
23.5 hours) or 1 hr (24 - 168 hours).
Example of remote control display
• In the case of 23.5 hours (* )
1
15-EN
2
4
• In the case of 34 hours (* 2 )
Number of days Time
shows 1 day (24 hours).
shows 10 hours. (Total 34 hours)
3
Push button.
• display disappears and the timer
appears, and or
(When ON timer is activated, the timer and the
ON timer appear and other displays
disappear.)
4
Cancel of timer operation
Push button.
Timer display disappears.
1 ) or
NOTE
2 )
• When the operation stops after the timer reaches
the preset time, the Repeat OFF timer resumes the
operation by pushing button and stops the
operation after the time of the timer has reached the
set time.
SWING/FIX
• When is pushed while the OFF timer function
of the air conditioner is active, the indication of the
timer function disappears and then appears again
after about 5 seconds.
This is due to the normal processing of the remote
control.
6

Installation

 Location
• Avoid installing near machines emitting high frequency waves.
• Not suitable for chemical plants such as liquefied carbon dioxide refrigerant plants.
• Places where iron or other metal dust is present. If iron or other metal dust adheres to or collects on the interior
parts of the air conditioner, it may spontaneously combust and start a fire.
• A failure may occur in certain locations such as the following:
• Areas with large amount of oil droplets (including machine oil) or vapors
• Salty areas near oceans, etc.
• Hot springs emitting sulfidizing gas.
• Heavily acidic or alkaline places.
Special maintenance or parts are required for use in the above places. For details, contact the dealer where you
purchased the product.
• Leave enough space around the air intake and outlet of the outdoor unit so ventilation is not restricted.
• Avoid places where strong wind may blow against the outdoor unit's air intake and discharge.
• Ensure drain water from the outdoor unit is channelled into places with good drainage.
• Attach the air filter to the indoor unit. If not, dust may accumulate on the heat exchanger or other parts in the air
conditioner and cause a water leak.
• Keep a distance of at least 3.3 ft. (1 m) between the air conditioner, remote control and a TV or radio. Failure to
observe this precaution may cause visual disturbance or noise.
• Leave a distance of at least 4.9 ft. (1.5 m) between the air discharge and a fire alarm. If this precaution is not
observed, the alarm may not work properly or detect an actual fire.
 Be careful of operation sounds
• Locate the unit in a place secure enough so that the sounds and vibrations do not increase.
• If something is placed near the air discharge of the outdoor unit, noise may increase.
display flashes. • Do not disturb neighbors with cool/warm air or noise coming from the air discharge of the outdoor unit.
– 8 –
EN
16-EN